Codebender logo

TX_attiny_weather by Hazcoder

Cloned from Sketch TX_attiny_weather by volthauslab

This sketch is missing a short description
The transmitter is a very basic configuration of the Attiny85 with a pull up resistor on the reset line. A transmitter module is attached to digital pin '0' and the DHT11 data pin attaches to digital pin 4. Attach a wire of 17.2 cm as antenna (for a much better antenna see step 5). The software is as follows:

Embed This Sketch

Use the following HTML code to embed the sketch code above in your blog or website.

<iframe style="height: 510px; width: 100%; margin: 10px 0 10px;" allowTransparency="true" src="https://codebender.cc/embed/sketch:179821" frameborder="0"></iframe>

Embed The Serial Monitor

You can also embed the Serial Monitor section! Just use this HTML code.

<iframe style="height: 510px; width: 100%; margin: 10px 0 10px;" allowTransparency="true" src="https://codebender.cc/embed/serialmonitor" frameborder="0"></iframe>