Codebender logo

Project - load cell readout by seagoon

Cloned from Sketch load cell readout by driss.gougili

Rigging tension gauge
This sketch uses the blend micro to interrogate a load cell input through a HX711 Sparkfun board to ultimately display the load via bluetooth to a smart phone or tablet. (haven't sorted that bit yet!). There is also an overload test (currently set at 2000) which lights LED 13 if above that.

Embed This Sketch

Use the following HTML code to embed the sketch code above in your blog or website.

<iframe style="height: 510px; width: 100%; margin: 10px 0 10px;" allowTransparency="true" src="https://codebender.cc/embed/sketch:354198" frameborder="0"></iframe>

Embed The Serial Monitor

You can also embed the Serial Monitor section! Just use this HTML code.

<iframe style="height: 510px; width: 100%; margin: 10px 0 10px;" allowTransparency="true" src="https://codebender.cc/embed/serialmonitor" frameborder="0"></iframe>
  • 2016-10-30 peter.john.whitmore

    Hi, just getting started with the blend micro... not sure about the wiring for the load cell (was using uno until now, but readbear seem to have different pinout to the standard nano) do you have the wiring diagram?